RAPTOR Davit Base Plastic Insert

  • Includes fixings
NOTE
  • Replaceable wearable part.
MATERIALS
  • Arm & mast – manufactured from high grade structural aluminium
  • Brackets, endcaps, supports – powder coated stainless steel
  • Base – G350 Grade Steel, galvanised finish
RATING
  • 12kN Single Person Use + Rescue
  • 400kg safe working load
DIMENSIONS

OH510.1600: Reach – 1000mm / Height – 1600mm / Overall Height – 1800mm / Weight – 41kg

OH510.2200: Reach – 1000mm / Height – 2200mm / Overall Height – 2400mm / Weight – 48kg

OH514.1600: Reach – 1400mm / Height – 1600mm / Overall Height – 1800mm / Weight – 43kg

OH514.2200: Reach – 1400mm / Height – 2200mm / Overall Height – 2400mm / Weight – 50kg

SUBSTRUCTURE REQUIREMENTS
  • Minimum concrete thickness – 200mm*
  • Concrete strength – minimum 32 mPa
  • Concrete may need to be verified by engineer regarding reaction loads
  • Minimum 250mm edge distance
CHEMSET EXPOXY APPLICATION
  • Stainless steel or HDG M16 allthread x 180mm
  • 18mm hole, Min 120mm embedment into concrete*
  • Recommended epoxy (chemset) adhesive – Hilti HIT RE-500
CAST-IN APPLICATION
  • 300mm x 300mm u-bolt cage
  • Minimum concrete thickness – 200mm*
  • Minimum 150mm embedment(Refer installation manual)

*Concrete specifications depend on davit type.

COMPLIANCE

The RAPTOR davit arm system is designed to conform with requirements of the Australian & New Zealand Standards AS/NZS 5532:2013 AS/NZS/ISO22846, AS/NZS1891 and relevant codes of practices and guidelines.

TESTING

Testing and performance of the RAPTOR davit arm system is based on requirements of Australian Standards AS/ NZS 5532:2013.

PRODUCT WARRANTY

10 years from date of purchase subject to correct installation. Use and maintenance of the RAPTOR davit arm system to be in accordance with manufacturer’s specifications and recommendations. (This excludes wearing parts.)

INSPECTION AND MAINTENANCE

Inspection and certification required every 12 months by Height Safety Equipment Inspector in accordance with manufacturer’s specifications and requirements of Australian Standards AS/NZS 1891. and AS/NZS 5532. Pull testing of the davit arm fixings is required (unless clearly marked as ‘cast-in’).

IMPORTANT NOTE

Failure to supply and/or install proprietary product in accordance with above standards and codes, specifications and instructions voids complete system certification and/or warranty.